$A$ student measured the diameter of a small steel ball using a screw gauge of least count $0.001 \, cm$. The main scale reading is $5 \, mm$ and the circular scale division coinciding with the reference level is $25$. If the screw gauge has a zero error of $-0.004 \, cm$,the correct diameter of the ball is: (in $, cm$)

$A$ steel wire of diameter $0.5 \text{ mm}$ and Young's modulus $2 \times 10^{11} \text{ N m}^{-2}$ carries a load of mass $M$. The length of the wire with the load is $1.0 \text{ m}$. $A$ vernier scale with $10$ divisions is attached to the end of this wire. Next to the steel wire is a reference wire to which a main scale,of least count $1.0 \text{ mm}$,is attached. The $10$ divisions of the vernier scale correspond to $9$ divisions of the main scale. Initially,the zero of vernier scale coincides with the zero of main scale. If the load on the steel wire is increased by $1.2 \text{ kg}$,the vernier scale division which coincides with a main scale division is. . . . Take $g = 10 \text{ m s}^{-2}$ and $\pi = 3.2$.

The least count of the main scale of a screw gauge is $1\, mm$. The minimum number of divisions on its circular scale required to measure $5\,\mu m$ diameter of a wire is

$A$ screw gauge of pitch $0.5\,mm$ is used to measure the diameter of a uniform wire of length $6.8\,cm$. The main scale reading is $1.5\,mm$ and the circular scale reading is $7$. The calculated curved surface area of the wire to appropriate significant figures is $......\,cm^2$. [Screw gauge has $50$ divisions on the circular scale]

In an experiment,the angles are required to be measured using an instrument where $29$ divisions of the main scale exactly coincide with $30$ divisions of the vernier scale. If the smallest division of the main scale is half a degree $(= 0.5^\circ)$,then the least count of the instrument is:

In a Vernier calipers, when both jaws touch each other, the zero of the Vernier scale is shifted to the right of the zero of the main scale and the $7^{th}$ Vernier division coincides with a main scale division. If the value of $1$ main scale division is $1 \text{ mm}$ and there are $10$ Vernier scale divisions, then the Vernier caliper has